How To: Create your own water bottle holder

The card stock used is a celery card stock that is 2 by 7 and 3/4. You then fold the ends of the card 2 inches into the card on both sides. So now it should look like two 2 inch squares on the ends that are folded and then a rectangle in the middle. The designer paper used measures 3 and a 1/4 by 1 and 7/8 inches. To make the decoration on top you use the paper punch that punches a 1 and 1/4 inch circle in the paper and then you use the scallop punch around the area of that same punched out hole to give a ridged flower appearance. You take some liquid glue and dab a couple of spots on the paper cut out and place it on one of the 2 inch folded squares on the card stock. Then you take the 1 and a 1/4 hole punch and punch out the middle of are that the cut out was glued. This opening is where the head of the water bottle will go. Then you attach the designer paper to the middle rectangle of the card stock with some adhesive. On the cut out paper you make to stamps: The "thank you" and the "flower shape" stamp leaving at least an inch of space in between the stamp areas. You cut out the flower with the 3/4 inch hole punch and the "thank you" with the 1 and 1/4 inch hole punch. You then place a dimensional adhesive sticker on the back of the flower punch out and then place it in the middle of the "thank you" punch out. Then punch out a 1 and 3/8 inch and 1 and a 1/2 circle out of two different pieces of colored paper and glue the "thank you" cut out to the 1 and 3/8 cut out and then that you glue to the 1 and 1/2 inch cut out and then glue that to a another scallop punch out. You poke two hole at the two top ends of the folded 2 inch square on the card stock and put two studs in the holes. Then glue the previous layered stamp cut out to the 2 inch square fold. The two studs hold the 2 inch square fold to the rectangle and make a pocket. You can put a pouch of crystal light in there for something that people can drink the water with and then your done.